Informations et ressources scientifiques
sur le développement des zones arides et semi-arides

Accueil du site → Doctorat → Royaume-Uni → 1989 → Solar induced ventilation in the Algerian and similar climates

University of Leeds (1989)

Solar induced ventilation in the Algerian and similar climates

Boucher, Ammar

Titre : Solar induced ventilation in the Algerian and similar climates

Auteur : Boucher, Ammar

Université de soutenance : University of Leeds

Grade : Doctor of Philosophy (PhD) 1989

Résumé
In hot climates ventilation can be a useful means of cooling dwellings, if the outside air be cooler than that inside the dwelling. Often, in hot regions the outside air is so hot during the day that cooling by ventilation is of no benefit until the evening when the outside air gets cooler. Ventilation can then be beneficial, and can be promoted by a sun-warmed cavity or ’solar chimney’ added to a building on the sunward side. The cavity may be of any material of high thermal capacity. Heat from the sun is stored within the walls forming the cavity and heats the air within. The cavity is closed at the top and bottom by dampers. These, when opened in the evening, allow the buoyant hot air contained within to rise, drawing cooler outside air into the building. This process continues until the stored energy is consumed. The performance of a typical cavity to induce ventilation into a house is studied experimentally and theoretically. The measurements are made on a full-scale model in the steady state. Cavity width and air inlet area to the cavity are important parameters in this study. Measurements are made on the temperature and velocity of the air. Observations on air flow patterns in the room and the cavity are made. A steady state analysis is compared with the measurements. A dynamic model is developed based on a finite difference technique, and used to examine the performance of the cavity in various circumstances. The results show that air movement can be produced by a sun-warmed cavity if the dimensions of inlet and cavity width are kept at certain values.

Présentation (White Rose)

Version intégrale (16 Mb)

Page publiée le 4 octobre 2012, mise à jour le 22 octobre 2018